Glass Sided Tilting Flume Experiment

Glass Sided Tilting Flume Experiment

50000.00 - 500000.00 INR/Pack

Product Details:


Price And Quantity

  • 50000.00 - 500000.00 INR/Pack
  • 1 Pack

Trade Information

  • 10 Pack Per Month
  • 10-30 Days
  • Export Worthy
  • ISO

Product Description

Specification of Glass Sided Tilting Flume 

If the requirement is for a flume suitable both for teaching & project/research work then the very popular has to be the flume of choice, offering high levels of dimensional accuracy, a wide selection of models & accessories & formatting in various configurations. A glass sided tilting flume with fabricated all stainless steel bed. A working cross-section of 300mm wide by 450mm deep and available in standard working lengths of 5m, 7.5m, 10m, & 15m. Longer lengths are available to special order in increments of 2.5m. Completely self-contained and comprising the working section, moulded inlet and discharge tanks, a series of sump tanks, a pump, an electronic flow meter, a jacking system and a control console. The channel section is fully glazed with large clear panels of toughened glass. This is coupled with careful design of the side support profiles to provide excellent visibility and allow flow visualization of the full working height of the flume. The glass panels are sealed using a rubber section compressed by an aluminum alloy clamping strip. The flume bed is manufactured to high tolerances and designed with an integral web support frame to give the flume a high degree of rigidity and stability. Rigid dowelled joints are used to connect the sections. The overall strength and rigidity of the design allows excellent stability figures to be achieved and eliminates the need to provide adjusting screws or to perform periodic setting up of the flume to maintain its specification. No under frame or support structure other than jacks is necessary.

Technical Details of Glass Sided Tilting Flume 

  • Width: 300 mm
  • Depth: 450 mm
  • Length: As ordered (multiples of 2.5m) Note: overall length is 3.25m longer than the working section defined
  • Walls: Toughened glass
  • Bed: Exclusively fabricated from stainless steel
  • End tanks: GRP (Glass Reinforced Plastic)
  • Sump tanks & pipework: VC (Polyvinyl chloride) & PE (polyethylene)
  • Pump: Close coupled centrifugal
  • Flow regulation valve: Hand wheel operated butterfly
  • +ve slope: 1:40 max (1.4°)
  • -ve slope: 1:200 max (0.28°)
  • Flow meter: Electro-magnetic
  • Maximum flow rate 30 Liters/sec
  • Bed stability: <1.0mm (typical) at 400mm water depth
  • Side wall stability: <0.5mm (typical) at 400mm water depth


Enter Buying Requirement Details
Email Id
Mobile number

Other Products in 'Hydraulics And Hydrology Instruments' category

trade india member
DIDAC INTERNATIONAL All Rights Reserved.(Terms of Use)
Developed and Managed by Infocom Network Private Limited.