CRP Dynamometers

Product Description

CRP DynamometersAll 3 CRP dynamometer types have separate driveshafts for the forward and rear dynamometer to facilitate the connection of two motors. It is therefore possible to control the speed of the forward and the rear dynamometer independently from each other. Alternatively, the two driveshafts can be connected through a gearbox normally with a transmission ratio of1: 1 so that it is possible to drive both the forward and the rear dynamometerat the same speed in opposite directions, from one motor..Specification of CRP Dynamometers Rated torque: 7NmRated thrust: 250 NMaximum speed (provided that suitable drive equipment is available): 1800 rpmCurrent supply for the measuring system (constant voltage): d.c. or a.c.Sensitivity at rated torque and thrust, output voltage/supply voltage, approximately: 1.5 mV/VTorque measurement: Input bridge resistance, approximately: 274Output bridge resistance, approximately: 240Recommended supply voltage: up to 8VMax. supply voltage: 20VThrust measurement: Input bridge resistance, approximately: 133Output bridge resistance, approximately: 120Recommended supply voltage: up to 6VMax. supply voltage: 10VNet weight without calibration device,approximately: 17 kgRated torque: 3 NmRated thrust: 30 NMaximum speed (provided that suitable drive equipmentis available): 1800 rpmCurrent supply for the measuring system (constant voltage): d.c. or a.c.Sensitivity at rated torque and thrust, output voltage/supply voltage, approximately: 1.5 mV/VTorque measurement: Input bridge resistance, approximately : 274Output bridge resistance, approximately: 240Recommended supply voltage: up to 8VMax. supply voltage: 20VInput bridge resistance, approximately: 133Output bridge resistance, approximately: 120Recommended supply voltage: up to 6VMax. supply voltage: 10VNet weight without calibration device,approximately: 17 kgRated torque: 24NmRated thrust: 700 NMaximum speed (provided that suitable drive equipment is available): 1800 rpmCurrent supply for the measuring system (constant voltage): d.c. or a.c.Sensitivity at rated torque and thrust, output voltage/supply voltage, approximately: 2 mV/VTorque measurement: Input bridge resistance, approximately : 259Output bridge resistance, approximately: 240Recommended supply voltage: up to 8VMax. supply voltage: 20VInput bridge resistance, approximately: 378Output bridge resistance, approximately: 350Recommended supply voltage: up to 8VMax. supply voltage: 20VNet weight without calibration device,approximately: 21 kgInclusive stern tube, however without gearbox (1 kgforce = 980665 N)