Automotive Bus Systems Basics Trainer

Product Description

Description: This system is specifically designed to teachbasics of bus technology. It is ideal for introduction into networked systemsin modern vehicles. It has two transmitter and receiver units. Each unit can begiven an address, such as those used in automotive ECUs. The transmitter can becustomized 2 x 4 bits to send messages over a single bus line. These messagescan be measured with an oscilloscope and recorded. On the receiver side 8outputs can be connected to LEDs, which correspond to a typical vehicle lighting.Course Contents: Bus Electrical Systems, topology Serial communication, information packetswith address and data blocks, processing Assign and transmit data in binary modebinary number system conversion of values, bit significance LSB / MSB addresses Hexadecimal, conversion of binary values inhexadecimal address assignments Collisions of data packets Using the oscilloscope, identifying andinterpret messages Driving a vehicle lighting in differentsituations by sending different messages to their respective receivers via asingle cable Components: 3 x Switch for sending 8 x Data switch 16 x Address switch 1 x Transmitter unit with transparent windowto Interior 1 x Receiver unit with transparent window toInterior incl. 8 control LEDs 8 x Signal outputs 12 x LEDs in printed vehicle with 8connection terminals 2 x Data cable connectors 2 x Power sockets 12V DC